| 010020 error – The CheckSum Read On The Flash SIMM Is InCorrect |
| 010021 error – The Base DRAM Or The RAM SIMM Tests Failed |
| 010022 error – The SWATH RAM Test Failed |
| 010023 error – A Fuse On The Main PCA Has Blown |
| 010025 error – Problem Initializing The Encoder Pulse Generator |
| 010030 error – One Of The Two Interconnect Boards Not Detected |
| 010031 error – The Printhead Primitive Driver ASIC Test Failed |
| 010032 error – Fan Test Failed – Current Not Detected In One Or Both Fans |
| 010033 error – The DC Motor ASIC Test Failed |
| 010034 error – One Of The DC Motor Has Failed |
| 010035 error – One Of The Stepper Motors Has Failed |
| 010036 error – ADC Test Failure In The Main PCA |
| 010037 error – ADC Test Failure In The Carriage PCA> |
| 010038 error – A Printhead Voltage Could Not Be Set – Main PCA Failure |
| 010039 error – A Printhead Voltage Could Not Be Set – Carriage PCA Failure |
| 010040 error – The Amnient Temperture Measured Is Out Of The Normal Range |
| 010041 error – Problem In Setting The Printhead Voltage |
| 010042 error – The Status Of One Of The Optical Sensors Is Not Stable When It Should Be |
| 010100 error – Error Reading In The EEROM |
| 010101 error – An Action Outside The EEROM Limits Has Been Performed |
| 010102 error – Physical EEROM Write And/Or Write Operations Failed. The EEROM Data That Is Written Does Not Match The Data That Is Read |
| 010110 error – The Content Of The Permanent Configuration Area Of The EEROM Is Not Valid When The Printer Is initialised In Service Mode |
| 010111 error – The Content Of The User Configuration Area EEROM Is Not Valid When The Printer Is initialised |
| 010120 error – The Content Of The Permanent Configuration Area Of The EERom Is Not Valid When Printer Is initialised In Normal Mode |
| 010121 error – One Of The Banks Of The User Area Was Corrupted While Writing Or Reading In That Area |
| 020000 error – Error In Finding The Primer Home Position |
| 020001 error – Error In Finding The Elevator Home Position |
| 020002 error – Error In Finding The Refill Arm Home Position |
| 020003 error – Error In Finding The refill Stepper Motor Home Position |
| 020004 error – Error In Finding The Service Station Home Position |
| 020005 error – Elevator Has A Problem Reaching A Desired Position |
| 020006 error – The Refill Position In The Y-axis In Not Calibrated |
| 020010 error – Problem With Fine Movement of The Y-Axis Motor |
| 020011 error – Error During Initialization Of The Y-Axis |
| 040xxx error – MIO Card Error |
| 040601 error- The MIO Card Does Not Support The MIO – 6 Protocol Cards With Vision – 5 Or Below Can Not Be Used With The Plotter. Version – 5.1 Cards Behave As Expected But Does Not Support PML Intructions |
| 050000 error – The Line Sensor Has Problems Finding The Mark Encoder |
| 060000 error – The Line Sensor Is Not Functioning Properly Because There Is To Much Ambient Light |
| 060200 error – Incompatible Firmware And Carriage PCA |
| 060399 error – Incompatible Firmware And Line Sensor |
| 07xxxx error – Firmware Error |
| 08xxxx error – PostScript Error |
| 080001 error – Hard Disk Drive Installed Without PostScript |
| 09xxxx error – Problem With The Hard Disk |
| 09004 error – PostScript Installed Without The Hard Disk Drive |
